Installation diagram
1.在屋頂欲安裝處開孔
2.將底座圓孔處和開孔處接合
3.底座的上端放入屋脊板下方,以自攻螺絲釘將底座四周固定後,再將底座四周及鎖
螺絲的部位塗上矽利康填縫膠,避免漏水情況產生
4.接著將中座與底座接合後,用水平尺將中座調整水平,已自攻螺絲釘固定,
5.最後將頭座以自攻螺絲釘固定即完成安裝步驟
溫馨叮嚀:
1.中座調整水平,可使頭座的耐用年限增長!
2.記得機所有鎖過螺絲釘的地方都塗上矽利康填縫膠,避免漏水哦!
1. Drill a hole which is ready to install a wind driven turbo ventilator on the roof.
2. Make the opening in the bottom connect a hole on the roof.
3. Put top of the bottom to underneath of the ridge board. Use self drilling screws to fasten
the bottom.Then, put silicone around the bottom and the places of screws,
in order to avoid water leakage.
4. Make the middle part connect the bottom. Next, use spirit level to adjust the middle part,
and use self drilling screws to fasten the middle part.
5. Finally, use self drilling screws to fasten the upper part.
Note:
1. The useful life of the upper part could be much longer, through using spirit level to
adjust the middle part.
2. Please remember to put silicone on the places of screws so that preventing from
water leakage.